plaza посмотри снизу должен быть штифт прямо под рычажком на рис :Figure 128 Это правда другая АКПП тоже с линкольна тока легковушки
1. Inspect the transmission case thoroughly for
wear, damaged surfaces, or stripped threads.
2. Inspect the rear case caged needle bearing and
replace as necessary using the appropriate tools
to remove and install (See Figure 127).
Note: If replacement is necessary ensure that
the sealing ring end of the bearing faces rear,
as shown in Figure 127.
3. Install new manual lever seal into case using
the appropriate seal driver (See Figure 128).
4. Install the manual lever, inside detent lever and
park rod assembly, manual lever retaining pin
and torque nut to 48Nm (35 ft.lb.). Refer to
Figure 129.
Note: Do Not allow the wrench to strike the
manual valve inner detent lever pin.
