Полезный сайт

CHIMIK

Старожил форума
5 345
44
Калининград/Vilnius
#2
http://cgi.ebay.com/ebaymotors/ws/e...m=300153942842&ssPageName=STRK:MEWA:IT&ih=020

http://cgi.ebay.com/ebaymotors/ws/e...m=220152486860&ssPageName=STRK:MEWA:IT&ih=012

http://cgi.ebay.com/ebaymotors/ws/e...m=190155748592&ssPageName=STRK:MEWA:IT&ih=009

http://cgi.ebay.com/ebaymotors/ws/e...m=190155664200&ssPageName=STRK:MEWA:IT&ih=009

Every vehicles / motorcycles have an Electronic Control Unit (ECU). This unit electronically manages and monitors your vehicle’s performance. The ECU is made to meet government regulations. In other words, your engine could perform much better and could be getting more power if the ECU is replaced. This replacement could easily cost drivers over $1500. The PE module will make the same adjustment without the high cost of replacing the complete ECU. The PE module simply wires into the factory harness of the IAT sensor. The module will work with the sensor to provide a new signal to your vehicles computer, or ECU. The ECU then adjusts your air/fuel and timing advance curves to new performance settings. Our PE module eliminates costly parts and installation of ECU components (many ECU mods require you to solder and modify the main board), and still safely and legally provides the same end results. There is no risk of damage to the engine or electrical system since the modified sensor signal will always remain within the manufacturer’s recommended specifications. The module works in conjunction with your vehicles ECU and will not affect engine reliability. Installation is very simple. All instructions are included and install should take no longer than 15 minutes. The PE module can even quickly and easily be removed or re-installed at any time with the hardware included.

Подбор с http://www.4x4vilnius.com/
 

CodeX

Banned
Banned
6 650
12
#3

Димчик

Активный участник
4 337
6
Неризновск
#4
Я уже схемы по электрике двигла распечатал. :wink:
Спасибо, полезный сайт. :)
 

Фордзон

Участник
191
0
Ford Ranger 2003
Королёв
#6
Читайте схемы внимательно!!! Я на свою машину нашел две ошибки в схемах!! Сначала подумал, что я чего-то не понял, но автоэлектрик сказал, что схема работать не будет. Я потом допёр-не были показаны две перемычки, так что будьте бдительны.